Snapple Cooler Deluxe-but-still-fuxx0red Edition

Under the guidance of the wise Blondiechu, we created a new cold finger using the finest components known to man: copper pipe, end caps, and solder. After much polishing, we were left with...a copper mushroom.

To contain the snapple, I got a bigass plastic cup that the dorms give people at the beginning of the year. Then I got a smaller (1 litre) styrofoam cup from my friend's messy floor. We filled the big cup up with expanding foam for insulation then stuck the smaller cup inside it to hold the snapple. Here are some pics of the weight we had to put on the big cup to stop the foam expanding out all over the place.


After about an hour, the foam seemed to stop expanding. You can see the styrofoam cup in the middle, the insulation foam, and the outer cup.


After gluing on the hsf and the cup cap, we had a new snapple cooler. I used some phone wire I got off a friend to extend the power cables so I could put the cooler wherever I wanted.

Snapplemark 2009 Benchmark Results:

The cooling was about as good as before, and the copper remained nice and shiny. The snapple tasted a little less metallic, and I think copper oxide is a little less poisonous than rust so I probably would have died a little slower.

Fuxx0redmark 2003 Benchmark Results:

Extremely fuxx0red. Overnight the foam continued to expand so much that it bent out the base of the cooler, making it incapable of standing on its own anymore. Also the inner cup got crushed.

Everytime you make a ghetto hardware mod, God kills a kitten.